![]() ![]() I used two coats and sanded with 220-grit in between. Now just use some polyurethane to add a little shine to the piece. This should be simple – just make sure you center them into the base. Clamp and let that glue dry for 30 minutes as well.įinally, glue the curved pieces to the bases. Make sure it is at a right angle and simply glue a long and short piece together. I used a straight edge to make sure the bottom was flush.Ĭlamp these pieces together and let the glue dry for at least 30 minutes. Glue a curved piece onto each side of your center pieces. Time for the glue-up! Get your clamps and wood glue ready at hand. Let the stain dry according to the instructions on the can. I didn’t find it worth the extra thought and effort in this case. However, if you are concerned with that, you can choose not to stain the areas you will be gluing. This is not a piece that will hold weight. Some people tend to think the stain will interfere with the adhesion, but I haven’t found that to be a problem. *Pro Tip: you will be gluing all of the pieces together with wood glue. Cover the entire piece with stain, then use a towel to wipe off the excess. Remember to wear protective gloves! The sponge tends to get just enough stain on the wood and is able to get into the crevices in the curved pieces. Use a sponge brush to stain all of the pieces. First, sand with 120-grit, then move up to 220-grit for a nice smooth finish. An orbital sander works for the straight pieces and sides, but I sanded the curved pieces by hand so they wouldn’t get damaged. My curved pieces were about 9.5″x3.5″ so I cut my long pieces at 10.5″ and my short pieces at 4″. This just needs to be tall enough and long enough to encase the curved pieces. In this photo, I traced the bottom edge of the center piece about 1/4″ wider than the curved piece, leaving a right angle on the back side which will attach to the base (if that is confusing, scroll down to assembly instructions.) Cut this shape with the scroll saw twice. Once your curved pieces are cut, lay one onto the rest of your board and trace a line imitating the outer shape. ![]() (I am definitely an amateur scroller!) Cut out all 4 pieces. ![]() This is a pretty simple pattern for a beginner. Use a spray adhesive to adhere the stencils to your wood.īefore you start cutting, drill pilot holes into the sections you’ll be cutting out in the middle of the design.īegin cutting on the scroll saw, starting with the inner cuts then working your way out. You may want a little extra to hold onto when cutting with the scroll saw. I used a French curve stencil and traced out 4 pieces. Once you have them traced, cut 4 pieces of wood at least the length that you need. The first step in this project is to make the curved parts of the bookends. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |